![]() Then, after making a Trunk connection between Cisco Switches, you must configure the connection between R1 and SW1 as Trunk. After you determine the VLANs on the network topology, you must configure the TCP/IP settings for the VPCSs. The latest status of the network topology is as in the following image. Since we will use two interfaces on Switch-2, 300 MB RAM is enough.Īfter performing the above steps, click the wiring option and then wiring all devices in the work area. On the Network tab, set the number of Adapters to 4 to add an interface to the Switch. Set the Cisco L2 Switch RAM to 400 MB and then click the Network tab. Since the L2 Switch is Qemu-based, boot problems with low RAM may occur. In the window that opens, increase the amount of RAM for the Switch. Right-click / configure on the Layer 2 Switch. ![]() To configure VLAN in GNS3, first, add one Cisco Router to the workspace.Īdd Layer 2 Switch and 2 VPCS computer to the workspace.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |